Need help?Do you have a question about the Realistic 32-1200C and is the answer not in the manual?
Lists the impedance values for various inputs like mic, phono, tape.
Specifies the output signal levels for tape and main outputs.
Details the input sensitivity required for rated output levels.
Indicates the range of frequencies the mixer can process.
States the total harmonic distortion at rated output levels.
Describes the equalization response for phono inputs.
Measures how well left and right channels are isolated.
Specifies the level for the monitor output to headphones.
Defines the highest signal level before distortion.
Explains the function of the main power on/off switch.
Describes how to combine or separate audio channels for output.
Controls the overall output volume of all sources simultaneously.
Adjusts the volume for the PHONO 2 or AUX input.
Allows smooth transitions or crossfades between two input sources.
Adjusts the volume for the PHONO 1 or TAPE input.
Sets the headphone listening volume for CUE or MAIN OUT.
Port for connecting headphones to monitor audio.
Allows independent adjustment of each microphone's input level.
Controls the stereo placement of microphone signals.
Indicates the output signal levels for the left and right channels.
Selects between the PHONO 1 and TAPE input sources.
Enables headphone monitoring of inputs before they go to the main output.
Selects between the PHONO 2 and AUX input sources.
Connects the unit to a standard AC power outlet.
Output connections for sending audio to an amplifier or receiver.
Output connections for recording mixed audio onto a tape deck.
High-level input for devices like CD players or VCRs.
Input for connecting a stereo tape deck or other high-level source.
Input for turntables, with separate connections for magnetic or ceramic cartridges.
Identical to PHONO 2 Jacks, for a second turntable.
Input jacks for connecting microphones.
Terminals for connecting turntable ground wires to reduce hum.
Explains how to route mono signals and convert stereo inputs to mono.
Describes how to monitor inputs privately using headphones before mixing.
Details how to adjust the stereo placement of microphone signals.
Lists common problems and their solutions for the mixer.
General| Brand | Realistic |
|---|---|
| Model | 32-1200C |
| Frequency Bands | 3-band EQ per channel |
| Type | Stereo Mixer |
| Power Supply | AC Power |
To Next Page