Realistic Pro-30 - Storing Found Frequencies

.
4. Press
eitherEl or
lvl
to start search.
E]will
start
search
from
highest frequency and
go
down, whilelTlwill
start from the lowest
frequency and
go
up.
5.
You can control the speed
o.f
the
Search
by using
lspggDl
tfre
same way
you
use
it
during scanning.
6. Search
will stop
when
a signal
is
detected.
To restart search,
,
Press
I
orE.
ln the
program
mode, the search range
will
be displayed
each
time
lLlMifl
is
pres*d.
tt is
impossible to change the lower
frequency
only: to change the lower
frequency
you
must change
the
higher
frequency first The higher frequency can be changed
any time.
Storing
Frequencies
lf
you
want
to
enter some of the
frequencies found
during
search,
do this:
1.
Press
IMOM
when
your
PRO-30
firrds a
frequency
you
want
to
store.
2. Use
lMANUAII
to select a
channel
to enter the
frequency
your
PRO-30 found.
The
display
will show
the
frequency
currently
'stored
on the
channel, but don't worry
-
the
old
frequency
will
be erased when
you
start
to enter the
new
one.
3.
Press
[FcMl.
4,
Press
IMONI
again.
The
new
frequency
found
during
the search
will be
displayed.
5,
Press
leNteRl
to
put
the new frequeney into
the
channel in
place
of the old frequency.
6.
Press
either[elorElto
resume the
search. To
return to manual
or
program
operation,
Bress
IMANUALI
or
IFG
wil.
To
resume the seareh
from one of
the
limit frequencies,
press
ILIM-ITJ
and
then
EI
orE .
-13-