arrow will put the grill in “FULL” mode, which raises the temperature to the maximum possible
(varies with fuel, ambient temperature, etc.)
3 Temperature Display Screen
Displays temperature readouts (either Actual or Set Point) error messages, and power up readout.
LED Messages:
rEC, GrLL, 5.10
These three screens will display when the appliance is plugged into a GFI
electrical outlet. This describes the make and model of the Smart Grill
Technology™ processor. (The 5.10 in this example identifies the software
revision – your grill may indicate a different version of software.)
350F
This is the default temperature at start up. The temperature setting range is from
180ºF to 500ºF while the actual temperature readout ranges from ambient to 500ºF.
ER-1
This error code is to indicate the appliance has overheated.
ER-2
This error code indicates a failure to ignite.
ER-3
This error code indicates a power failure causing the grill to cool.
COOL
Displays after turning the grill off, during cool-down.
FULL
Displays in FULL mode, and maximum fuel rate is utilized.
Note: To reset an error, press ON or OFF after correcting the problem.
4 Temperature Display Toggle
This button toggles the LED temperature display between Actual and Set Point. (See 5)
5 Display Indicator Light
The LED beside Actual or Set-Point is used to indicate which temperature is presently displayed.
! Actual: Current Temperature Inside Your Rec Tec
! Set Point: The temperature setting you input.
6 Xtreme Smoke Button
Xtreme Smoke is automatic between 180 and 250 degrees. The toggle is not functional in
this model. In Xtreme Smoke mode, the grill controls air flow and fuel rate to maintain lower
temperature and create more smoke. The mode gives you a great smoke flavor for your “slow and
low” cooks. It automatically shuts off above 250 degrees.
12 ©2014, Rec Tec Industries, LLC
To Next Page
Loading...
