rec tec grill RT-700 - User Manual

Questions and Answers

X
xmunozAug 19, 2025
Why is my rec tec grill smoking excessively or the smoke is discolored?
- M
  millertracieAug 19, 2025
  Excessive or discolored smoke from your Rec Tec Grill can be due to: * **Excess ash in the fire pot:** Inspect the burn pot for ash and clean it if needed. It's recommended to clean the fire pot every 3-5 uses. * **Blower fan issues:** Unplug the grill, remove the access panel, and check the blower fan for obstructions, loose connections, or bugs. Remove any obstructions. If the problem continues after powering the grill back on, unplug it, manually spin the fan for several revolutions, and plug it back in. The blower fan may need to be replaced if the issue persists.
D
Daniel BarberAug 22, 2025
What to do if my rec tec grill will not heat up to or maintain proper temp?
- A
  Amy WeaverAug 22, 2025
  If your Rec Tec Grill isn't heating up or maintaining the correct temperature, consider these factors: * **Pellet quality/age:** Check the pellets to make sure they are dry and haven't turned into sawdust. If there's an issue, remove the pellets from the hopper, clean the ash from the firepot, and replace them with clean, dry pellets. * **Insufficient airflow:** Examine the fire pot for any blockages or ash accumulation. * **Excess ash in fire pot:** Check the fire pot for ash and clear it out if necessary.
L
lance77Aug 25, 2025
What to do if pellets are not being delivered to fire pot in my rec tec grill?
- S
  Steven GonzalezAug 26, 2025
  If pellets aren't being delivered to the fire pot in your Rec Tec Grill: * **Hopper obstruction:** Unplug the grill and remove the pellets from the hopper. Clean the hopper of any obstructions or buildup. * **Auger failure:** Remove the cooking grate and flame deflector plate. Check if the auger is turning in the fire pot (it turns very slowly). If it's not turning, there may be an obstruction in the hopper. Clean out the pellets and try again. If the problem persists, the auger motor may need to be replaced.
C
Cameron RodriguezAug 28, 2025
What to do if my rec tec grill fire continues to go out?
- E
  Emily SandersAug 28, 2025
  If the fire in your Rec Tec Grill keeps going out: * **Pellet quality/age:** Inspect the pellets to ensure they are dry and haven't broken down into sawdust. If the problem continues, remove the pellets from the hopper, clean the ash from your firepot, and replace them with clean, dry pellets. * **Hopper obstruction:** Unplug the grill. Remove pellets from the hopper and clean any obstructions or buildup.
A
amberbakerAug 30, 2025
Why does my rec tec grill say ER-3?
- P
  padillalauraAug 31, 2025
  If your Rec Tec Grill displays an ER-3 error code, it could be due to: * **RTD unplugged/ grill over heated:** Check the RTD connection and allow the grill to cool down. Turn the grill off, then back on again to reset the controller and clear the code.
R
rachel43Sep 2, 2025
What causes flare ups in my rec tec grill?
- A
  Alexandra FergusonSep 2, 2025
  Flare-ups in your Rec Tec Grill are often caused by: * **Excessively greasy food while temperature setting is too high:** Reduce the temperature to 350 degrees or below when cooking foods with high fat content.
A
Amber MartinezSep 5, 2025
What causes excessive grease or build up in rec tec grill?
- K
  katelynbrightSep 5, 2025
  Excessive grease or buildup in your Rec Tec Grill is often caused by: * **Excessively greasy food:** Cook at 350 degrees or below when cooking excessively fatty foods.
R
Robert OwensSep 9, 2025
Why is smoke coming from the hopper of my rec tec grill?
- M
  Marcus PhillipsSep 9, 2025
  Smoke coming from the hopper of your Rec Tec Grill can be due to: * **Excess ash in fire pot:** Clean the grill interior. * **Pellet level very low in hopper:** Add more pellets to the hopper. * **Excess pellet dust lining auger tube causing burn back:** Remove pellets from hopper and vacuum out hopper, auger tube, and fire pot.
S
smithvanessaSep 12, 2025
Why does my rec tec grill say ER-1?
- J
  Jose IngramSep 12, 2025
  If your Rec Tec Grill displays an ER-1 error code, it is often due to: * **Power Failure:** Make sure the grill is plugged into a working GFCI outlet, and the outlet is not tripped. Turn the grill off, then back on again to reset the controller and clear the code.
K
Karen WebbNov 15, 2025
What to do if my rec tec grill will not light or turn on?
- H
  hendrixjacobNov 15, 2025
  If your Rec Tec Grill won't light or turn on, there are several potential causes: * **Power:** Ensure the grill is plugged into a working GFCI outlet that hasn't tripped. Unplug the grill and inspect the fuse. * **Fuse:** Replace the fuse and try again. * **Ignitor:** Remove the cooking grate, flame deflector, and drip pan. Check the fire pot. If pellets are feeding, the blower fan is running, but the grill still isn't lighting after 10 minutes, the ignitor rod may need replacement. * **Auger motor:** Remove the cooking grate, flame deflector, and drip pan. Check if the auger is turning in the fire pot (it turns very slowly). If not, there might be an obstruction in the hopper. Clean out the pellets and try again. If the problem continues, the auger motor may need replacement. * ...