RECO EasyLine RM-216 C User Manual

RM-216 C.10 Easy Line Documentation
RDN 10000029 14 13.05.2014
8 Text messages on the display
Display Explanation
Reset status, text version and differential pressure.
The text message is displayed for approx. 1 second after the voltage is
switched on.
Reset RM200VXX
+ - XXXX Pa
Controller is not enabled through inputs I1 and I2.
Stand By
+ - XXXX Pa
Controller is enabled through inputs I1 and I2.
The Max ∆p switching point has not yet been reached.
Cleaning Off
+ - XXXX Pa
Controller is enabled through inputs I1 and I2 and the Max ∆p switching
point has been exceeded.
Cleaning On
+ - XXXX Pa
Controller is enabled through inputs I1 and I2 and the ∆p alarm switching
point has been exceeded.
Cleaning On
+ - XXXX Pa
alternating with
DP-Max Alarm
+ - XXXX Pa
Controller is enabled through inputs I1 and I2 and the Max ∆p switching
point has not yet been reached with inputs D1 and D2 bridged.
Extern Clean ON
+ - XXXX Pa
Controller is enabled through inputs I1 and I2 and the Max ∆p switching
point has been exceeded with inputs D1 and D2 bridged.
Extern Clean OFF
+ - XXXX Pa
∆p mode switched off
DP-Mode Off
+ - XXXX Pa
Down time cleaning active
DTC Cleaning ON
+ - 000 Pcs
The alarm switching point for the service hours counter has been
exceeded.
Call Service
+ - XXXX Pa
A connected I/O module RM-LV8 or RM-LV16 is out of order
or
the total number of valves (parameter P06) is set incorrectly.
RM-LVX Alarm
+ - XXXX Pa
Locked parameter in parameter selection mode
Lock
XXXX The differential pressure value displayed depends on the parameter setting.

RECO EasyLine RM-216 C Specifications

General

Brand	RECO
Model	EasyLine RM-216 C
Category	Control Unit
Language	English