44 Chapter 5. Post Installation
5.2. Populating the Directory Tree
During installation, a simple directory database was created for you. In addition, a simple directory
structure was placed in the database for you to use. This directory structure contained basic access
control and the major branch points for the recommended directory structure.
Now you need to populate your database with user entries. There are several ways you can create
and populate your directory suffixes. These are explained in detail in the Red Hat Directory Server
Administration Guide.
The main methods are:
• Create a database from LDIF: Use this method if you want to use the sample directory data shipped
with Directory Server, if you are importing entries from another directory via LDIF, or if you have
more than a few entries to add at once. For more information about LDIF, refer to the Red Hat
Directory Server Administration Guide.
• Start your Directory Server with an empty database and import data over LDAP: This method
requires you to populate your directory using an LDAP client such as Directory Server Gateway
or the ldapmodify command-line utility. Use this method if you have just a few entries to add at a
time. For information on setting up the Directory Server Gateway, refer to the Red Hat Directory
Server Gateway Customization Guide. This document is provided with Red Hat Directory Server
Resource Kit.
As you are populating your directory, consider your access control needs and set access control ac-
cordingly. For more information on access control, see the Red Hat Directory Server Deployment
Guide and the Red Hat Directory Server Administration Guide.
To Next Page
Loading...
Need help?
General
