Chapter 7. Troubleshooting 61
TRANSPORT_NAME[10]=tcp
NDD_NAME[10]=tcp_smallest_anon_port
NDD_VALUE[10]=8192
WARNING: tcp_deferred_ack_interval is currently 50 milliseconds.
This will cause the operating system to insert artificial delays
in the LDAP protocol.
It should be reduced during load testing.
An entry similar to the following can be added to
the /etc/rc.config.d/nddconf file:
TRANSPORT_NAME[10]=tcp
NDD_NAME[10]=tcp_deferred_ack_interval
NDD_VALUE[10]=5
WARNING: largefiles option is not present on mount of /opt,
although it is present on other file systems.
Files on the /opt file system will be limited to 2GB in
size.
NOTICE : /opt partition has only 90MB free.
Continue [n]?
Example 7-1. Sample dsktune Output
7.2. Common Installation Problems
Clients cannot locate the server
First, try using the host name. If that does not work, use the fully qualified name (such as
www.domain.com), and make sure the server is listed in the DNS. If that does not work, use
the IP address.
If your NIS domain is different from your DNS domain, the fully-qualified host and domain
name presented by the installer may be incorrect. These values must be corrected to use the DNS
domain name.
The port is in use
You probably did not shut down a server before you upgraded it. Shut down the old server, then
manually start the upgraded one.
Another installed server might be using the port. Make sure the port you have chosen is not
already being used by another server.
LDAP authentication error causes install to fail
If you are installing Directory Server in a network that uses NIS naming rather than DNS nam-
ing, you may get the following error, with incorrect.DNS.address replaced by the DNS
address you attempted to use:
ERROR: Ldap authentication failed for url
ldap://incorrect.DNS.address
To Next Page
Loading...
Need help?
General
