red lion C48C - Factory Settings; Factory Settings Chart

Factory Settings
This parameter is used to reset all parameters to their
factory defaults. The Factory Settings Chart below shows
the settings for each programming parameter.
FACTORY SETTINGS CHART *
-28-


Reset all programming parameters to their
Factory Settings.

Do not reset parameters to Factory Settings.

DESCRIPTIONMODE
OUTPUTS
3 2 1
 
ACCESS OUTPUT TIME VALUES


OUTPUT RESOLUTION


OUTPUT 1 TIME


OUTPUT 2 TIME


OUTPUT 3 TIME

 

REVERSE ANNUNCIATOR LOGIC


OUTPUT POWER-UP STATE

USER INPUTS

USER INPUT 1
 

USER INPUT 2
 

USER INPUT B
 
 
USER F1 KEY
 

PROGRAMMING CODE VALUE


SCROLL DISPLAY


SERIAL BAUD RATE & PARITY


SERIAL UNIT ADDRESS


ABBREVIATE SERIAL MNEMONICS


PRINT OPTIONS


PRINT & RESET COUNT VALUES

PRESCALER OUTPUT MODEL ONLY

PRESCALER OUTPUT PULSE AT
 

PRESCALER OUT PULSE LENGTH


P1 TRACK P2


PRESET 3 VALUE


PRESET 2 VALUE


PRESET 1 VALUE


ACCESS PRESET VALUES
 
PRESETS

COUNTER 2 OPERATING MODE
 

COUNTER 2 ASSIGNMENT
 

COUNTER (1) OPERATING MODE
 ( )

COUNT MODE
 
COUNTER

DECIMAL POINT POSITION
 

PRESCALER VALUE


ACCESS PRESCALER VALUE
 
PRESCALER

NUMERIC VALUE ENTRY METHOD

REVERSE RELAY/OUTPUT LOGIC
3 2 1
RS-485 SERIAL OPTION (DUAL PRESET/BATCH MODELS ONLY)