red lion IAMS0002 - Error Indications; Readout at Hardware Error

To Next Page

To Previous Page

LP1109 19

Error indications

Readout at hardware error

Error search Readout Error cause

Test of internal CJC sensor CJ.ER

CJC sensor defect or tem-

perature outside range

Checksum test of the configuration in FLASH FL.ER Error in FLASH

Check measurement of analogue output current* AO.ER

1) No load on the current out-

put (only S4...20/S20...4 mA)

Communications test PGM / device NO.CO Connection error

Check that input signal matches input configuration IN.ER 1) Error levels on input

Check that saved configuration in PGM matches device TY.ER

Configuration is not IAMS

0002 / 0022 / 0020

Error indications in the display flash once per second. The help text explains the error.

* Does not apply to IAMS0020.

1) The error is reset by switching off and then switching on the supply voltage to the device.