RED DALIA - Page 40

38
10 - LOADING THE PELLETS
• Press 3 “menu” to conrm.
• Use the + - keys to select the test to be carried out.
• Press ''menu'' to conrm and ''esc'' to exit.
k - Chimney sweeper function (for maintenance operators only) -
This function can only be activated when the stove is on and power is supplied, and it forces operation of the boiler at the parameters
P5, with the ventilator (if present) in V5. Any corrections to the loading/smoke ventilation percentage must be read. This state lasts 20
minutes, the countdown is displayed on the panel.
The technician can stop this pressing the phase at any moment by quickly
Enable the "Chimney sweeper" function as follows:
• Press the ''menu'' key.
• Use the arrow keys to scroll through and select "Settings"
• Press “menu” to conrm.
• Use the arrow keys to scroll through and select ''Chimney sweeper function''
• Press “menu” to conrm.
• Use the + - keys to select "On" (O by default)
• Press ''menu'' to conrm and ''esc'' to exit.
l - Technical menu
To access the technical menu you must contact the assistance centre as it requires a password.
Access the "technical menu" as follows:
• Press the ''menu'' key.
• Use the arrow keys to scroll through and select "Settings"
• Press 3 “menu” to conrm.
• Use the arrow keys to scroll through and select ''Technical menu''
• Press 3 “menu” to conrm.
• With the + - keys, select "Product Type", "Service", "Counter memories", "Parameters".
• Press ''menu'' to conrm and ''esc'' to exit.
INFO MENU
• Product type
• Firmware version
• Software info
• Total hours
• No. of start-ups
• Rpm evacuator
• T. smoke
• Heat exchanger voltage
• Feed screw loading
• Flame