START-UP
Press key 1 (esc) to start up the appliance. The display will show ON with the ashing ame symbol. When the ame stops blinking, the
stove has reached the operating condition to “supply power”.
The default target room temperature is set at 20°C. To change this setting, follow the instructions in the adjustments menu; do the same
to set the heating water temperature and the speed of the ventilation fan (if provided). To activate an external thermostat, if present, see
the dedicated paragraph.
POWER SUPPLY
When start-up is complete, the panel with show ON with a constant ame at level 3 . The modulation of the ame for higher or lower
power is then controlled autonomously on the basis of reaching the set temperature.
(see also “OPERATING MODE” - “Set Flame”)
To Next Page
Loading...
