What to do if my REDCAT Motorized Toy Car won't steer or move?
If your REDCAT Motorized Toy Car won't steer or move, ensure the battery pack is charged. Also, check if the battery wires are loose and securely plug them in. Finally, follow the Quick Start Guide for the proper start-up sequence.
Why doesn't my REDCAT Kaiju NiMH battery charge last as long as it should?
If the NiMH battery charge for your REDCAT Motorized Toy Car doesn't last as long as it should, refer to the ESC Guide to set the ESC to NiMH battery. Also, completely charge the NiMH battery with an appropriate NiMH charger.
What does it mean if my REDCAT Kaiju Motorized Toy Car motor doesn’t work, but emits “beep-beep-, beep-beep-” alert tone?
If, after powering on your REDCAT Motorized Toy Car, the motor doesn’t work but emits a “beep-beep-, beep-beep-” alert tone, it indicates that the input voltage is abnormal, either too high or too low. Check the voltage of the battery pack.
What does it mean if the RED LED flashed rapidly on my REDCAT Kaiju?
If, after powering on the ESC and finishing LiPo cells detection (GREEN LED flashed N times), the RED LED flashes rapidly on your REDCAT Motorized Toy Car, the ESC might not have detected any throttle signal, so check if the throttle wire is reversely plugged in or in the wrong channel and if the transmitter is turned on. Another possibility is that the neutral throttle value stored on your ESC is different from the value stored on the transmitter, so re-calibrate the throttle range after you release the throttle trigger to the neutral position.
Install batteries into the RC controller for operation.
Steps to detach the vehicle's body shell for access.
Instructions on how to control the vehicle's steering direction.
Guide on using the transmitter trigger for braking.
Detailed steps for applying brakes using the transmitter trigger.
Adjusting steering trim for a neutral vehicle position.
Setting throttle trim to achieve a neutral throttle position.
Adjusting steering dual rate for maximum steering control.
Steps to remove the vehicle's body as part of shutdown.
Procedure to turn off the vehicle's power.
Instructions for safely removing the battery pack.
Important safety warnings and regulatory compliance information for the radio.
Diagram showing how to connect the receiver to other components.
Step-by-step guide on how to bind the transmitter and receiver.
Visual guide for programming the ESC settings.
Detailed explanation of each programmable ESC setting.
Guide on using an external card to configure ESC settings.
General| Scale | 1/8 |
|---|---|
| Motor Type | Brushless |
| Drive System | 4WD |
| Vehicle Type | Monster Truck |
| Battery Voltage | 11.1V |
| Radio | 2.4GHz |
| Suspension | Independent |
| Terrain | Off-road |
| Battery | LiPo |
To Next Page
