15
Crankshaft problems
Big end nuts slacken
Solve vibration, see vibration
Crankshaft bearing collapsed
Incorrect assembled after repair.
Remove, clean, use loctite
Rear roller shaking
Rear roller locked
Rear roller moves upwards with
hollow coring
Tough circumstances
Unlock
Change speed and PTO rev’s
Put roller free on the ground
Change machine settings.
13.0 MAINTENANCE.
Pre-Delivery-Inspection
Check bolts/ nuts
Connect the unit to a tractor
Run unit for 5 min
See instructions in this
manual
Look and listen
After first 20 hours
(new or repaired)
Grease PTO and rollers
Check bolts/nuts
Look closely at machine
4 shots each EP 2
After every 100 hours
Grease PTO and rollers
Check bolts/ nuts
Look closely at machine
Grease spindles front roller
4 shots each EP 2
After every 500 operating
hours.
Replace the oil in the
gearbox.
Use 80W90 (3 liters).
14.0 EU-Declaration
We, Redexim Utrechtseweg 127 3702 AC Zeist Holland, hereby declare fully on our
authority that the product:
VERTI-DRAIN 7117, WITH MACHINE NUMBER AS INDICATED ON THE MACHINE
AND IN THIS MANUAL,
to which this declaration relates is according to the stipulation of the 2006/42/EC directive
for machines as well as the following standards: NEN-EN-ISO 12100 : 2010 and NEN-EN-
ISO 13857 : 2008.
Zeist, 01/10/09
A.C. Bos
Manager Operations & Logistics
Redexim Holland
To Next Page
Loading...
