13
TESTING
To Test the Electronic Stimulation:
1. Place the tester firmly on the contacts of
the Collar Receiver.
2. Set the intensity (note - an intensity level
setting of 4 or less might not be enough to
light the tester).
3. Push the ‘Cont.’ button.
4. The tester light will light repeatedly when
the Continuous Stimulation button is pushed (the test
light will be brighter at higher intensity levels).
To Test the Beep:
1. Press the ‘Beep’ button.
2. An audible beep will be emitted any time the button is
pressed.
NOTE: Turn the Collar Receiver ON for Testing
NOTE: If the Collar Receiver is not responding to any sig-
nals from the Transmitter, the Collar Receiver may need to
be reprogrammed to the Transmitter (see page 14).
*Charging Error - If the SmartLED has a long blink every
other second while charging, the rechargeable battery pack
will need to be replaced. Contact D.T. Systems if the
problem persists after a few charging sessions.
To Next Page
Loading...