14
REPROGRAMMING
If your current Collar Receiver is not responding to the
Transmitter, it may need to be reprogrammed to the
Transmitter.
1. Hold the Magnet Indicator (Red Mark) on the
Transmitter directly against the Magnetic Switch
Indicator (“M” Mark) on the side of the Collar Receiver.
2. The LED Light inside the Collar Receiver will light
up solid for about 1 second followed by 6 flashes. You
must keep the Transmitter next to the Collar Receiver
during this time.
3. Continue to hold the Transmitter against the Collar
Receiver until the LED Light stays on solid. The Collar
Receiver is now in the Code Running Mode (the LED
light will stay lit for approximately 8 seconds while it is
in this mode).
4. Remove the Transmitter from the Collar Receiver
and press the ’Cont.’ and ’Beep’ buttons
simultaneously while it is in the Code Running Mode.
5. When the LED light blinks 3 times, the Collar ID is
now programmed and the Collar Receiver is now ON.
NOTE – Do not remove the Red Mark on the
Transmitter from the Red Mark on the Collar Receiver
until after the LED light stops flashing and stays on
solid or the Collar Receiver will not go into the Code
Running Mode. You must press the ’Cont.’ and ‘Beep’
buttons simultaneously while the LED light is lit solid.
To Next Page
Loading...