RedMax CHT220 - Page 7

1
5
Starter
Assembly
Fit the recoil spring in the starter pulley.
Place the extension spring exactly above
the groove in the starter pulley.
Attach the new starter cord. Attach the new starter cord.
Make sure the knot is as small as possible
and fi ts into the notch in the pulley.
Pulley diameter: Ø 3,3 mm.
Assembly
If the return spring has, despite all the
precautions, fl own out or if you intend to fi t
a new spring proceed as follows:
1. The spring, tensioned with a sturdy
plastic strap, is available as a spare
part.
2. The spring, tensioned with a sturdy
plastic strap, is available as a spare
part.
Press the extension spring into the starter
pulley.
3. Hold two fi ngers in one hand above
the recoil spring.
4. Press with the other hand and use
a screwdriver to push the extension
spring into the starter pulley.
Press down hard on the recoil spring and
carefully prise off the plastic strap.
5. Press down hard with one hand’s
fi ngers over the recoil spring.
6. Carefully prise off the plastic strap with
a screwdriver.
NOTE!
It is very important in step 6 above
to press down hard on the spring
in the starter pulley so it does not
fl y off.
If the spring, despite being careful, fl ies
off, it can be fi tted to the starter pulley by
twisting it in place using your thumbs.
Wear assembly gloves and protective
goggles.