EasyManua.ls Logo

RedMax CHTZ2400 - Adjusting Idling Speed

RedMax CHTZ2400
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7. Operation
1. When restarting the engine immediately after
stopping it, leave the choke open.
2. Overchoking can make the engine hard to start
due to excess fuel. When the engine failed to
start after several attempts, open the choke and
repeat pulling the rope, or remove the spark plug
and dry it.
STOPPING ENGINE (OP3)
1. Release the throttle lever and run the engine for
a half minute.
2. Shift the ignition switch to the “STOP” position.
Except for an emergency, avoid stopping the
engine while pulling the throttle lever.
RUNNING IN THE ENGINE
During the first 20 working hours, do not use the
hedge-trimmer at maximum power for long
periods.
ADJUSTING IDLING SPEED
Before adjusting the carburetor, clean the air
filter and warm up the engine. (OP5)
(1) air filter
Idle screw is adjusted in order to ensure a good
safety margin between idle running and clutch
engagement. (OP6)
(1) Idle screw
With the engine idling (3000 rpm), the blade
should not rotate. We recommend that you
have the dealer or an authorised mechanic
carry out any carburetor adjustments.
WARNING
IMPORTANT
IMPORTANT
NOTE
(1)
OP5
(1)
OP6
17

Related product manuals