Problem Cause
The engine becomes too hot. The air filter is clogged.
There is overload in the engine.
The airflow around the engine is not sufficient.
The engine speed regulator is damaged.
The oil level is too low.
There is dirt in the fuel line.
The spark plug is defective.
The battery does not charge. The connection at the cable connectors on the battery terminals
is bad. Refer to
To clean the battery on page 18
.
The charging cable is disconnected.
The charging system is defective.
The product moves slowly, with irregular
speed or not at all.
The parking brake is engaged.
The hydraulic release lever is engaged.
The drive belt on the transmission is loose or damaged.
There is air in the hydraulic system.
The drive of the blades do not engage. The drive belt on the mower deck is loose.
The electromagnetic coupling contact is loose.
A fuse is blown.
The transaxle leaks oil. The seals, housing or gaskets are damaged.
There is air in the hydraulic system.
The cutting result is unsatisfactory. The tire pressure is different on the right and left sides. Refer to
Tire pressure on page 19
.
The blades are damaged.
The cutting deck is damaged and not parallel to the ground.
The blades are blunt. Refer to
To examine the blades on page
21
.
The product is operated at too high forward or rearward speed.
Refer to
To get a good cutting result on page 15
.
The grass is long or wet. Refer to
To get a good cutting result on
page 15
.
There is grass blockage in the cutting deck. Refer to
To clean
the product on page 18
.
1997 - 003 - 07.12.2022 27
To Next Page
Loading...
