To do a 3-point turn
A correct turn will prevent damage to the lawn. The
goal is to turn when you move forward or rearward.
Do not turn in a tight circle on a stopped wheel.
1. Cut a row of grass.
2. Make a small turn (A) in the direction of the uncut
area of grass.
3. Pull the 2 control levers to the reverse position
and move the product rearward (B).
4. Push the control levers forward. To make a small
turn (C), pull harder on the control lever that is in
the direction of the row you have cut before.
5. Push the 2 control levers forward to cut the next
row.
Maintenance
Introduction
WARNING: Before you do any
maintenance work you must read and
understand the safety chapter.
Maintenance schedule
* = The instructions are not given in this operator's
manual.
X = The instructions are given in this operator's
manual.
O = Refer to the engine manual for instructions.
Maintenance schedule for the operator
Maintenance
Daily maintenance Do mainte-
nance at a
minimum of
1 time each
year
Maintenance interval in hours
Before After 25 50 100 300
Do a check of the parking
brake.
X * *
Do a check of the level of
the engine oil.
O
Do a check of the safety
system.
X
Make sure that there are
no fuel or oil leaks from
the product.
*
1718 - 001 - 23.08.2021 15
To Next Page
Loading...
