Always use good quality grease. Always use
recommended oil, refer to
Technical data on page
29
.
To lubricate the front wheels
• Grease the nipple (A) with a grease gun until
grease comes out from the top washer.
• Lubricate the joint bearing of the front wheels (B)
with a grease gun until grease comes out.
To lubricate the cutting deck
spindles
1. Set the cutting deck in mow position.
2. Lubricate each cutting deck spindle 2-3 strokes.
Note: Use a grease gun with a rubber hose
when you lubricate the cutting deck spindles.
Tightening torques
Engine crankshaft bolt 68 Nm / 50 lb ft
Deck pulley bolts 204 Nm / 150 lb ft
Lug nuts 102 Nm / 75 lb ft
Blade bolts 122 Nm / 90 lb ft
Spark plug 22 Nm / 16 lb ft
Troubleshooting
Troubleshooting schedule
If you cannot find a solution to your problems in this
operator's manual, speak to your RedMax service
agent.
Problem Cause
Engine does not start. The drive of the blades is engaged. Refer to
PTO (Power Take-
Off) button on page 5
.
Steering controls are not locked in the neutral.
The battery is too weak. Refer to
To charge the battery on page
18
.
There is dirt in the carburetor or fuel line.
The shut-off valve of fuel supply is closed or in incorrect posi-
tion.
The fuel filter or fuel line is clogged.
The ignition system is damaged.
1718 - 001 - 23.08.2021 25
To Next Page
Loading...
