EasyManua.ls Logo

RedMax EBZ6500 - Maintenance

RedMax EBZ6500
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
US-13
EBZ6500/RH
U
S
Maintenance, replacement, or repair of the emission control device and
systems may be performed by any non-road engine repair establishment or
individual.
9. Maintenance
Make sure that the engine has stopped
and is cool before performing any
service to the blower. Contact with
rotating blower fan or hot muffler may
result in a personal injury.
AIR CLEANER
Never operate the blower without an air
filter or with a deformed or broken filter
element because unfiltered dusty air
will quickly ruin the engine.
Check the air cleaner every 25 hours
of use or more frequently if used
under dusty conditions. A clogged
air filter may increase fuel
consumption while cutting down the
engine power. Never operate the
blower without the air filter or with a
deformed filter element because
unfiltered dusty air may quickly ruin
the engine.
CLEANING AIR FILTER:
1. Remove the air cleaner cover by pulling
the tab on bottom and take out the filter
element.
2. Use neutral detergent and warm water
to clean the filter element. After
cleaning, air dry the element
completely and moisten with a small
amount of 2 cycle motor oil.
WARNING
Do not apply 4cycle motor oils as they
may damage element.
Do not use mixture gasoline. This type
of gasoline does not contain much of oil
so that the element becomes dry after a
few hours.
(1) 2 Cycle Motor Oil
Soak the filter element into a 2cycle motor
oil. Squeeze the element to remove
excess oil so that it weighs 2 to 3 times
heavier than that of the dry element.
3. Place the filter element into the packing.
Set the packing into the air cleaner
body. Set the cover with 2 fixing screws.
(1) Cover Cleaner
(2) Screen
(3) Cleaner Body
(4) Element
(5) Packing
Assure that the screen is securely fitted
to the packing. Fit securely if it is loose.
Insufficient fixing of screws may cause
fall off of the cover and insufficient
sealing.
NOTE
NOTE
NOTE
Daily Every Every Every
System/Compornent Procedure or 25 hours 50 hours 100 hours
Before use after after after
Air Filter Inspect/Clean
Fuel Leaks Inspect/Replace
Fuel Filter Inspect/Replace
✔✔
Fuel Line Inspect/Clean
Spark Plug Inspect/Clean
Muffler Inspect/Clean
Muffler Spark Arrester Inspect/Clean
Cooling System Inspect/Clean
Screws/Nuts/Bolts Tighten
Air Inlet Net Inspect/Clean
Cylinder Exhaust Port Inspect/Clean
F18
F19
(1)
(2)
(3)
(5)
(4)
F20

Related product manuals