Why does my RedMax GZ500 Chainsaw engine start then stop?
Your RedMax Chainsaw engine might start and then stop due to several reasons. It could be due to incorrect fuel type, in which case you should drain the fuel tank and fill it with the correct fuel. Another cause may be a clogged air filter; clean or replace the air filter to resolve this. If the idle speed is not correct, speak to your servicing dealer.
How to fix a clogged fuel filter on my RedMax GZ500 Chainsaw?
To fix a clogged fuel filter on your RedMax Chainsaw, replace the fuel filter.
Product is intended for sawing in wood.
Chainsaw model with a fuel engine, focusing on safety and efficiency.
Be careful and use the product correctly. Can cause serious injury or death.
Always wear approved helmet, hearing protection, and eye protection.
Use two hands to operate the product for control.
Warnings about kickback, guide bar tip contact, and chain catcher.
Explanation of warning, caution, and note terms used in the manual.
Read warnings before use. Chainsaw is dangerous; understand manual.
Understand kickback effects, avoid faulty products, and use safely.
Checks and maintenance for safety devices like chain brake and front hand guard.
Instructions for assembling the guide bar and saw chain correctly.
Procedures for checking the product before use and mixing fuel correctly.
Details on gasoline and two-stroke oil requirements and mixing ratios.
Steps to prepare the chainsaw for starting a cold engine.
Explanation of two cutting techniques and related safety precautions.
How to use the spiked bumper for efficient cutting.
Techniques for cutting a trunk that is resting on the ground.
Requirements and advice for safely felling trees.
Importance of maintaining a safe distance during felling operations.
Importance of the felling hinge for controlling direction and safety.
Detailed steps for executing the safe corner method for felling.
Procedure for making the directional cuts to guide the tree felling.
Safety and overview of daily, weekly, and monthly maintenance tasks.
Checks and maintenance for safety devices like chain brake and front hand guard.
Information on guide bars and saw chains, including replacement criteria.
Troubleshooting steps for when the engine fails to start.
Troubleshooting steps for when the engine starts but then stops.
Specifications for engine, ignition, fuel system, and weight.
Owner's duties regarding maintenance, receipts, and proper use.
What the manufacturer covers under the emissions control warranty.
Specific advice and warnings to prevent kickback incidents.
Additional safety guidelines covering fatigue, fuel handling, and bystanders.
To Next Page
General
