9
2. Press the “Таймер” button to set the desired value. The timer
can be set to 3, 6, 12, 18, 24, 48, 72, 99 hours.
3.
Press the “Установка температуры/времени” button to select
the desired water temperature.
4.
Once you set the timer, it starts counting down. When the
timer is reset, the thermopot will start heating again.
III. CLEANING AND MAINTENANCE
Before cleaning, unplug the appliance. Gently wipe the inner tank
with a sponge and rinse with water. Clean it with citric acid once
a month. Wipe the thermopot body and lid with a damp cloth.
DO NOT clean with abrasives or chemical substances not recom-
mended for items that come into contact with foodstuffs.
DO NOT immerse the appliance in water or wash under running
water!
Descaling
Regular descaling of the thermopot will extend its service life.
Under normal use of the appliance, it is recommended to carry it
out at least once every 2–3 months.
1.
Fill the thermopot to three quarters of the maximum volume
and bring water to a boil.
2. When the thermopot switches to the heating mode, discon-
nect it from the mains, add an 8% solution of acetic acid to
it to the maximum level mark and leave it for several hours.
3.
Remove the lid, discharge water from the appliance and rinse
the tank thoroughly. Reinstall the lid.
4.
Pour clean water into the thermopot, close the lid until it
clicks, connect the power cord to the mains and wait for it to
boil.
5.
Disconnect the thermopot from the mains and discharge
water from it. Rinse it again with clean water.
6. If there is still some scale in the thermopot, repeat as de-
scribed above.
You can also use a special descaling agent. In this case, follow the
manufacturer's instructions.
Storage and transportation
Before repeated operation or storage completely dry all parts of
the appliance. Store the assembled appliance in a dry, ventilated
place away from heating appliances and direct sunlight.
During transportation and storage, do not expose the device to
mechanical stress, that may lead to damage of the device and/or
violation of the package integrity.
Keep the device package away from water and other liquids.
I V. BEFORE CONTACTING SERVICE
CENTER
Problem Possible cause Solution
The appliance does
not switch on
No power supply
Connect the appliance to a properly
working electric socket
To Next Page
Loading...
