Redon GTR - Page 52

52
redon.com
USER INTERFACE / ATC
ATC / CHANGE / Loading a Tool
1
2
3
4
Press the COLLET buon on the function
bar. Aer the conrmation pop-up window is
conrmed, the spindle collet will open.
The back end of the tool must enter inside
the collet up to a length of 15 mm.
Press the COLLET buon on the function bar
again to close the spindle collet.
The tool loading operation has been completed.
The same operation can also be peormed
for old or broken tools.
Aach the new tool to the collet as shown
in the image.
CAUTION! Please note that if there is a tool on the
spindle and you do not hold it, it will fall to the ground
when the collet opens.
1
2
3
4