Laser engraving machine for optical system is completed by mirror reflection and
focus lens focus, focusing mirror in the light path does not have the offset
problem , But the three mirrors is fixed by the mechanical parts, more likely to
offset, so the user must check the light path before each work and ensure it is
Equipment Notes
5.1 Fill the water before turning on the machine, we should observe the circulation of the
water at any time during the machine working, to ensure that the circulating water is
normal, and protect the normal working for laser tube.
5.2 Follow the sequence of the machine’s power on/off: when start the machine, firstly
open the water chiller, then open the power switch, open the laser switch at last. When
close the machine, firstly close the laser switch, then close the power switch, close the
water chiller at last.
5.3 Control the water temperature inside the laser tube, generally should not exceed 35
degrees. In winter, when we finish working, should let out the water inside the laser tube,
to prevent the laser tube damaged by frost.
5.4 Keep the machine clean, especially the lens, dirty lens will affect the reflecting
efficiency , processing samples and lens’ life, when cleaning the mirror and lens. should
use a cotton swab dipped in anhydrous alcohol to wipe slightly, to protect the surface of
lens.
5.5 Do not place the inflammable and explosive materials in the laser reflecting area and
around the machine, do not place reflective materials on the platform.
To Next Page
Loading...
