Maintenance
4.1 Replacement of water and cleaning water tank.( Recommends that cleaning
the water tank and replacement of recycled water once a week)
Attention: Before work the machine must ensure the laser tube filled with recycled
The quality of the circulating water and the water’s temperature direct impact the
life of the laser tube, recommend that using the pure water, and keeping the
temperature below 35℃. If more than 35 ℃ recycled water to be replaced or add
the ice water down to the water (Recommends that users select the cooling
machine, or use two water tanks) Cleaning tank (Changing the water): First we
should turn off the power, unplug the tube inlets, let the water of the laser tube
flow into the tank automatically, unplug the mains and signal lines. Open the tank,
then clean out the dirt of the water-cooled machine, replacement the recycled
water , connect the mains and signal lines, order the various joints. Turn on the
power, and run for 2-3 minutes (Make sure the laser tube filled with recycled
To Next Page
Loading...
