!
FIRST USAGE
Before plugging in the power cord, make sure to check input voltage of D100PRE
and be sure to match it with your wall voltage. Then insert power chord.!
Now you are ready to put the front power switch in “1 (ON)” position. Give tubes at
least thirty seconds to warm up.!Plug your signal cable into input jack then you are
ready to rock!
CHANNEL SWITCHES
Switches for Ch1, 2 and 3 or Clean, Vintage and Modern channels.
LEAD BOOST
As its big brother Duality 100, D100PRE featured a tube based gain boost for CH2
and CH3. This boost basically adds a gain stage somewhere in the signal path by
not afflicting your overall volume. Very useful if you’re looking for an “hot rod”
version of current channel you’re using.
Lead boost do not apply to CH1 (clean channel)
BRIGHT CAP
For the first time ever, bright cap is now remotely activable in one of our amplifiers.
You could now have choice of a darker/brighter version of the same sound.
Remote bright cap applies to all three channels (Clean, Vintage and Modern).
SOLO BOOST
Another big first time in a RedSeven amplifier, SOLO boost! It acts in the opposite
way to LEAD boost, by only increasing volume and not gain. Perfect for solos or just
to have a second step of volume, no matter in which channel you are in (yes, it acts
on all three channels).
Thanks to added eq section of SOLO boost, it can be used in couple modes:
1. Volume boost (with level > 0). It adds volume up to +15db for your solo parts.
Add or subtract highs and lows, if you need it. In flat position (center) it’s flat.
To Next Page
Loading...