!
SAVING A PRESET
Saving a preset is quite easy with D100PRE, it takes only few steps:
• Choose the desired combination of functions (channel, loop, solo, etc);
• Keep “STORE” button pressed for three seconds, until corresponding led turn
on, than release it;
• By using a MIDI devices able to send Program Change, send the desired PC
you want to memorize this particular combination;
• Store led will blink couple time for confirmation;
• You preset is now created.
You can save and re-save a preset infinite time. With this procedure you can use
different midi pedalbords or interface for recall preset without losing data, because
all presets are stored inside the amp. You only need to send the exact PC and it will
recall the same combination of functions every time forever.
You can exit the saving routing in anytime by pressing “STORE” switch three seconds
until the corresponding led turn off.
OUTPUTS
There’re two outputs on D100PRE’s back panel. Your “to go” output is the one
named “+4dB output”, and it’s the direct output from last tube of D100PRE. It’s a
full line level output signal, with enough headroom to drive any external line level
effect processor or any power amplifier.
The alternative one, is named “-10db output” and it’s an attenuate output to be use
only if you’d like to place instrument level pedals AFTER preamp and to avoid
clipping. While we highly discourage to do this, we thought this safe exit for you.
Missing volume from D100PRE must be recovered from power amp.
To Next Page
Loading...