07
Mounting the rear camera
2. Remove the Panel
Remove the inner panel of the trunk to
expose the rear wiring compartment of the
car. Open the trunk and look for a sturdy
inner panel covering the other side of the
license plate installation area. Then, insert
a decorative removal tool or another thin
device behind the panel and pry it apart.
3. Snake the cable
Use a trim removal tool to pop out tailgate
trim, then run the cable from outside of the
car into the trunk of your car.
4. After snaking your rear camera's
extension cable, connect the power cable
to your rear camera's extension cord.
NOTE:
If you need to install a trigger cable to activate the reversing guides,
SOHDVHŵQGWKHSRVLWLYHFDEOHRIUHYHUVLQJODPSDQGFRQQHFWWKHUHG
wire from the rear camera, you can also ask a professional for help.
To Next Page
Loading...
