RedZone DVS600 - Thermostat Installation; Safety Considerations; Installation Considerations

18
INSTALLATION
THERMOSTAT INSTALLATION
Safety Considerations
All wiring must conform to local and national electrical
codes. Improper wiring or installation may damage
thermostat.
INSTALLATION CONSIDERATIONS
Air Conditioner Model
Refer to Figures 12 through 13 for factory wiring details.
The Standard Model A/C thermostat may be wired with
or without connecting a common wire between the
indoor equipment and the thermostat. However, it is
recommended to use a common wire whenever possible.
Do not use a power-stealing thermostat. If an evaporating
coil is installed above the hot water coil, then a Freeze stat
must be installed to prevent potential freeze damage to
the hot water coil and subsequent waster escape.
Installation
Thermostat should be mounted:
• approximately5ft.(1.5m)fromoor;
• closetoorinafrequentlyusedroom,preferablyonan
inside partitioning wall;
• onasectionofwallwithoutpipesorductwork.
Thermostat should NOT be mounted:
• closetoawindow,onanoutsidewall,ornexttoadoor
leading to the outside;
• exposedtodirectlightandheatfromalamp,sun, 
fireplace, or other heat-radiating object which may
cause a false reading;
• closetoorindirectairowfromsupplyregisters
and return-air grills;
• inareaswithpooraircirculation,suchasbehindadoor
or in an alcove.
Refer to Figure 12 for thermostat wiring
diagram and thermostat installation instructions for
further details.
WARNING
Before installing thermostat, turn off all power to unit.
There may be more than one power disconnect.
Electrical shock can cause personal injury or death.
REDZONE
TM
DVS SERIES AIR HANDLER MANUAL