What to do if my Reebok Treadmill power does not turn on?
First, ensure the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet. After plugging in the power cord, make sure the key is inserted into the console. If the switch has tripped, wait five minutes, then press the switch back in to reset it.
Why is my Reebok 910 walking belt off-center?
If the walking belt is off-center, first remove the key and unplug the power cord. If the walking belt has shifted to the left, use the hex key to turn the left idler roller screw clockwise 1/2 of a turn.
Why does the incline of my Reebok 910 Treadmill not change correctly?
Hold down the Stop button and the Speed increase button, insert the key into the console, and then release the Stop button and the Speed increase button. Press the Stop button and then press the Incline increase or decrease button.
How to turn off demo mode on Reebok 910?
To turn off the demo mode, hold down the Stop button for a few seconds.
Proper procedures for connecting the treadmill's power cord and using a surge suppressor.
Step-by-step guide to operating the treadmill using manual speed and incline controls.
Steps to safely fold the treadmill for storage, noting weight requirements.
Solutions for power failures, console display problems, and demo mode activation.
General| Incline | 0-15% |
|---|---|
| Speed | 0-12 mph |
| Running Area/Surface | 60" x 20" |
| Display | LCD |
| Heart Rate Monitoring | Contact |
To Next Page