3. Turn the rear Adjustment Knob
counter clockwise and pull the
adjustment knob to insert the
Saddle Post into the Frame. Next,
bring the Saddle Post to the
desired height, release the
adjustment knob so the pin
engages into the holes of the
saddle post. Then turn the
Adjustment Knob clockwise to
retighten until it is snug.
Mount saddle to the horizontal
saddle post as shown in picture 4.
Finally, firmly retighten the saddle
mounting clamp and make sure
that the saddle is mounted in its
most horizontal position at the
middle of the rail.
To adjust the horizontal saddle
position, turn the small
adjustment knob counter
clockwise to adjust desired
horizontal saddle position and
retighten until it is snug.
Please don’t adjust the height of
the vertical saddle support
beyond the stop mark to avoid
instability.
Do not over tighten the Adjustment
Knob. Make sure the pin of the
adjustment knob is fully engaged and
Saddle Post does not slide while
riding.
To Next Page
Loading...
