Fusion TREADMILL
5
HARDWARE COMPARISON CHART
Hardware Pack:
The hardware fitting and tools required for assembly are packed in a bag with in the main carton. These are referenced by a
numerical code as outlined in the parts list (page 6). The pack configuration is shown below in order to ease identification.
Please open the bag carefully and place them on a piece of card, as below, to easily identify the parts before assembly.
NOTE: We suggest that you do not open the hardware pack until you are ready to assemble your FUSION TREADMILL .
When you open the pack, please do so carefully to ensure that the pieces remain in their position by their identification
numbers.
NO. DESCRIPTION QTY.
805
M8×43mm Bolt
4
806
∮8 Washer
8
830 M8x18 Allen head cap screw 4
107 Safety Key 1
A Allen Wrench 1
B Power Cord 1
C Lock Pin 1
B
C
MILIMETERS
To Next Page
Loading...
