Step 3:Follow the arrowhead to put up the console(please don’t put your hand on the connections),fix the console
to the stand post with 2pcs Threaded knob M8*20 . Please tighten all the bolts at this stage..
Step 4: Follow the arrowhead to put the right(mark R) and left(mark L) plastic covers on the stand post, put the
cover down to the bottom frame,make sure the screw holes on the cover and the bottom frame can fit together, fix
the bottom cover with two bolts (ST4*20) on either side,, Please tighten all the bolts to finish the assembly..
5
ASSEMBLY INSTRUCTIONS CONT
To Next Page
Loading...
