9
7. Set the console assembly face down on a soft
surface to avoid scratching the console assem-
bly. Hold the Right Handrail (95) near the con-
sole assembly. Next, insert the console wire into
t
he large hole in the Right Handrail and out of
the top as shown. If necessary, use needlenose
pliers to pull the console wire out.
A
ttach the Right Handrail (95) and the Left
Handrail (not shown) with four #8 x 3/4" Screws
(1) (only two are shown). Make sure that no
wires are pinched. Start all four Screws be-
fore tightening any of them; do not over-
tighten the Screws.
95
1
Console
W
ire
L
arge
Hole
1
7
8. Tighten a 1/4" x 1 1/4" Bolt (5) with a 1/4" Star
Washer (33) into the Handrail Crossbar (94) and
the bracket on each side of the console assembly
(only one side is shown).
Remove the wire tie from the console wire.
Remove the tie from the Cage Nuts (88) in the
Right Handrail (95) and the Left Handrail (not
shown). If necessary, press the Cage Nuts back
into place.
5
33
94
Console
Assembly
Wire
Tie
8
9. Have a second person hold the console assem-
bly near the Right Upright (78). Connect the Wire
Harness (38) to the console wire. See the inset
drawing. The connectors should slide to-
gether easily and snap into place. If they do
not, turn one connector and try again. IF THE
CONNECTORS ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAM-
AGED WHEN THE POWER IS TURNED ON.
Then, remove the long tie from the Wire Harness.
Set the console assembly on the Right Upright
(78) and the Left Upright (not shown). Be care-
ful not to pinch the wires.
Console
Assembly
Console
Wire
Long
Tie
38
78
88
9
38
Console
Assembly
Console
Wire
Console
Wire
95
To Next Page
Loading...
