10
11. Connect the wire on the Chest Pulse Receiver
(not shown) to the wire extending from the con-
sole assembly. Reattach the Pulse Receiver
Cover (70) to the console assembly with the two
#8 x 3/4" Screws (4). Make sure that no wires
are pinched. Discard the other wires included
with the receiver.
11
70
Wires
4
70
A
ntenna
1
0
84
12. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key
in a secure place; the hex key is used to adjust the walking belt (see pages 23 and 24). To protect the floor
or carpet from damage, place a mat under the treadmill.
10. Locate the chest pulse kit. Hold the Chest
Pulse Receiver (53) so the antenna is ori-
ented as shown. Attach the Chest Pulse
R
eceiver to the Pulse Receiver Cover (70) with
the #3 x 1/4" Screw (84) included in the chest
p
ulse kit.
53
Console
Assembly
To Next Page
Loading...
