Electricians, please ensure a copy of the Installation
Instructions are left with the end user for future reference
Installation Instructions
• To protect against the risk of electrical shock, do not immerse the unit, cord or plug in water or other liquid.
• When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
• This unit has rotating parts and safety precautions should be exercised during installation, operation and maintenance.
• Guards must be installed when fan is within reach of personnel or within 2.3 metres of working level or when deemed advisable for
safety.
• To prevent re or shock hazard, DO NOT expose this appliance to rain or moisture.
• Dangerous high voltages are present inside the motor enclosure. To avoid electrical shock, DO NOT open the motor enclosure.
Refer all servicing to qualied personnel only.
• To protect against re, electrical shock and injury to persons, do not immerse the unit, plug or cord in water or spray it with liquids.
• No naked ame sources, such as candles, should be placed on or near the product.
• Ventilation should not be impeded by covering the ventilation openings. Slots and openings are provided for ventilation to ensure
reliable operation of the product and to protect it from overheating.
• Place the fan on a stable level service when operating to avoid overturning.
• Only connect to a suitable AC 220-240V ~50Hz mains socket.
• Do not operate the fan in the presence of explosive and/or ammable fumes. Do not place the fan or any parts near an open ame,
cooking or other heating appliance.
• Do not operate the fan with a damaged cord or plug, after a malfunction, or if it was dropped or damaged in any way.
LOCATION
• The unit must be located and installed in accordance with AS/NZS 3000 and local building codes relating to damp situations.
• Ensure adequate air intake into the room exists through windows, vents or under the door to replace the displaced air.
• Regulations concerning the discharge of air must be fullled.
• Ensure the fan is not placed near drapes, curtains, or any objects that may be drawn into the fan.
POWER
AC220-240V ~50Hz electrical supply is required. The unit can be connected to a lighting or power circuit if loading permits. All
electrical work must be carried out in accordance with AS/NZS 3000 or latest edition thereof, and local building codes and regulations.
Ensure the power supply is isolated before commencing installation. Electrical wiring must only be done by a licensed electrician and a
“Certicate of Compliance” must be issued at completion of the installation.
Page 2 of 6
Kado Aspect Flush Mount Inline Exhaust
To Next Page
Loading...