8
Supplemental Display Notes
• "-LO-" appears on the display when indicating an open circuit
(i.e. probes are not in contact with source.)
• "-CH-" appears on the display when no sensor is connected to a
specic channel.
Software Installation
Note: The data logger is still running off its internal batteries when
plugged into the computer. Be sure there is sufcient battery power
before plugging the data logger into a computer or data may be lost
or corrupted.
Install the included software by placing the supplied program disc in the
PC's CD-ROM drive. If the installation program does not automatically
start, open and browse the CD-ROM drive from your computer. Double
click on the CV2 Datalogger le and follow the on-screen prompts to
install the software.
If your computer does not have a CD drive please visit
www.reedinstruments.com/software to download the latest R5003 software.
Note: The Windows Installer package should be used to properly install
the software as it automatically installs the required drivers. It is
recommended to restart your computer after installation before using
the software for the rst time.
Full specications and Operating System compatibility can be found on
the product page at www.reedinstruments.com.
If you have specic questions related to your application and/or questions
related to software setup and functionality please contact the nearest
authorized distributor or Customer Service at info@reedinstruments.com
or 1-877-849-2127.
Software Operation
The software operating guide can be found on the R5003 product page
under the resources tab at www.reedinstruments.com
REED Instruments
1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.com
To Next Page
Loading...
Need help?
General
