3
Introduction
Thank you for purchasing your REED R6210 Heat Stress WBGT Meter.
Please read the following instructions carefully before using your instrument.
By following the steps outlined in this manual your meter will provide
years of reliable service.
Product Quality
This product has been manufactured in an ISO9001 facility and has been
calibrated during the manufacturing process to meet the stated product
specications. If a certicate of calibration is required please contact the
nearest authorized REED distributor or authorized Service Center. Please
note an additional fee for this service will apply.
Safety
• Never attempt to repair or modify your instrument. Dismantling your
product, other than for the purpose of replacing batteries, may cause
damage that will not be covered under the manufacturer's warranty.
Servicing should only be provided by an authorized service center.
• Avoid electromagnetic interference which may cause erratic readings.
• Do not touch the black ball during a test as the results may be inaccurate.
• If the black ball is damaged or deformed, it will provide inaccurate
measurement values.
CAUTION
Please place the meter in a warm temperature and low
humidity environment for 24 hours after the meter has been
exposed to an overly humid environment.
REED Instruments
1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.com
To Next Page
Loading...
Need help?
General
