8 Performance + Electric Scooter User Manual
Folding & Carrying.
Folding your REEL Scooter Safely
Make sure the electric scooter is turned off before
attempting to fold. Holding the front pole, loosen the
lock lever by twisting to your right. This will release the
lever that is pointing upwards. Pull this lever down. The
front pole can then be lowered, allowing the scooter to
fold. Once folded, attach the clip (found near the bell on
the handlebar) to the clamp on the rear wheel mudguard.
To unfold the scooter, unhook the clip attached to the
back wheel mudguard. Slowly elevate the front pole to a
standing position and lock both levers in place.
Charging your REEL Scooter
.
The charging port is located underneath the foot plate.
1. Open the cover and
connect the charger.
Important: Close the cover once the charger has been disconnected.
Only use the REEL charger provided when charging the scooter.
Carrying your REEL Scooter
The scooter should only be carried using the locked
front pole. This can be done with one or two hands.
2. Once charging is
complete, remove
the charger. Ensure
cap is closed after
charging.
To Next Page
Loading...