Reely GT2 EVO - Switching the Digital Code

18
16. Switching the Digital Code
Thetransmitterenablesyoutocontrolreceiverswiththedigitalcode„AFHDS“and„AFHDS2A“.Exworks,thetrans-
mitterissettotheenclosed„AFHDS2A“-encodedreceiver.
IfyouwanttooperateaREELYreceiverwiththedigitalcode„AFHDS“,thetransmittermustbeswitchedrstandthen
the receiver must be bound to the transmitter (see following chapter).
To switch the digital code at the transmitter, proceed as follows.
• Switch off the transmitter.
• Movethesteeringwheelforthesteeringfunction(seegure1,item2)toonesidetothestopandkeepitthere.
• Pushandholdthebindingbutton(seegure2,item14).
• Switchonthetransmitterwiththeon/offswitchwiththesteeringwheeldeectedandthebindingbuttonpushed.
• Release the steering wheel and the binding button.
• IfthegreenLEDforundervoltageisashingcontinually,thetransmitterhasswitchedtothedigitalcode„AFHDS“.
IfthegreenLEDisashingwithinterruptions,thetransmitterhasswitchedtothedigitalcode„AFHDS2A“.
• Pushing the binding button again saves the currently set digital code.
• Switch the transmitter off and then on again so that it sends in the set digital code.
Important!
 Thereceiverenclosedwiththeremotecontrolsystem„GT2EVO“workswithcode„AFHDS2A“.Therefore,
always observe that the right code is programmed at the transmitter!