Need help?Do you have a question about the Reflex ACT III RD and is the answer not in the manual?
Assembling the Bottom Hole Assembly with the ACT III RD tool.
Integrating the ACT III RD tool into the core inner tube assembly.
Activating and synchronizing the ACT III RD tool with its controller.
Procedure for breaking the core off bottom while recording orientation.
Initializing a second ACT III RD tool after a break has been recorded.
Using the depth display for core breaking and orientation recording.
Retrieving orientation data using dip and depth display features.
Transferring the recorded bottom of hole orientation to the core.
Step-by-step guide to installing the ACT II Digital Auditor software.
Process for downloading and printing orientation data using the software.
Instructions for using the Reflex Orientation Transfer Device for core marking.
To Next Page
General