11
A Sync Cord is included with the base. Not available on Queen, Full or King size bases.
The Sync Cord connects the two control boxes to a single remote for the synchronization of two bases.
Disconnect the Battery Backup Box cable from each Control Box
or splitter cable. Make note where the cable was plugged in.
Plug bases back into the power source.
If bases become mismatched, pressing the FLAT button will re-
sync the mechanical positions.
Connect the male end of each Sync Cord to Control Box or
splitter cable. Insert it into the same port that you disconnected
the Battery Backup Box from in Step 2.
Check to ensure all cords are securely attached. Both remotes
will now operate both bases simultaneously.
Unplug bases from power source.
Connect each Battery Backup Box male connection to the sync
cord female connection (Refer to illustration at right).
STEP 3
STEP 6
STEP 2
STEP 5
STEP 1
STEP 4
PERFORMANCE NOTES
syncing two bases (optional)
Battery
Backup Box 1
Sync Cord
Battery
Backup Box 2
Control Box 1 Control Box 2
The system is now linked. Buttons pressed on either remote
will control both bases simultaneously.
To Next Page
Loading...
