7
installation guide
STEP 7
STEP 8
STEP 9
STEP 10
Carefully flip the base over on to its legs. Important: Two people
are required to move the bed base. Do not drag across the floor.
Do not rest frame on its side, excessive pressure may damage
the legs.
Plug the Power Cord into a power source.
A surge protector is recommended.
Ensure that batteries are correctly installed. Quickly test remote
functions to verify proper setup before placing mattress on
base. Return the base to a FLAT position before placing the
mattress on top.
Setup is now complete!
Test all functions on remote.
To install the mattress retainer bar, insert each end of the
bar into the holes at the foot of the platform.
For customer support, call Customer Service: 1-800-268-4414
To Next Page
Loading...