RADIO OPERATION
1. Press the button on unit to select the FM function.
2. Tune to desired station by pressing the TUN.+/ or TUN.-/ button on unit, the display
will show the band frequency. Example: FM 97.10 MHz. If the radio receive Stereo signal,
“ST” will show on the display.
3. Press and hold the TUN.+/ or TUN.-/ BUTTON, the unit will scan the frequencies until
a broadcasting station strong enough for good reception is found.
4. Extend FM TELESCOPIC ANTENNA to its full length and gently move the unit back and
forth to get the best reception, or place the unit in an open location.
5. To turn off the radio, press the button to select other functions, or press and hold
the button to turn off the unit.
RADIO AUTO SCAN (SEARCH)
Press the /SCAN button on unit, the unit will conduct auto scan and program until having
found a strong signal. The unit will start to broadcast from the P01 after searching finished. Use
the M.+ or M.- button to choose between the preset stations.
RADIO STATION MEMORY OPERATION
You may pre-store 30 (FM) radio stations in memory for your preference.
1. Press the TUN.+/ or TUN.-/ button to select the first desired station. Then press and
hold the PROG./M./P-MODE button on unit, “P01” will show on the display.
2. Use M.+ or M.- button to choose the desired sequence you want to store, then press the
PROG./M./P-MODE button on unit to confirm.
3. Search another station, repeat steps (1) & (2) until all desired stations stored. Up to 30
stations can be programmed.
4. To choose between the stored stations, press the M.+ or M.- button.
CD OPERATION
Discs for Playback
This system only can playback digital audio CD, finalized digital audio CD-Recordable (CD-R)
discs, finalized digital audio CD-Rewritable (CD-RW) discs.
LOADING A DISC
1. Press the /FUNC. button on until to select “CD” mode.
2. Press the OPEN/CLOSE button to open the CD door, “OP” will be shown on the display.
3. Place an audio CD DISC into the tray with the front side facing up.
4. Close the CD door.
The display will show a flashing “- - -”, then the total number of tracks and the playback will
starts from the first track.
5. To remove the CD, press STOP button and press OPEN/CLOSE button to open CD door, the
display will show “OP”. Hold the CD by its edges, and carefully take it out.
To Next Page
Loading...