Note:
Make sure the disc is stopped before opening the CD DOOR.
To ensure good system performance; wait until the unit completely reads the disc before
proceeding.
If no disc loaded into the tray, or the disc is unreadable, the display will show “NO”.
PLAYING A DISC
1. The unit will start playback from track 1 after reading finished. The track no. and play time
would be shown on the display.
To interrupt playback, press the button. The play time will flash on the display.
To resume playback, press the button again.
2. To stop playback, press the STOP button, the total number of tracks appears on the display.
SELECTING A DESIRED TRACK/PASSAGE
To select a desired track
Press the TUN.+/ or TUN.-/ button in stop mode or during play until the desired track
appears on the display. It will start play automatically. If the unit is in stop mode, press
to start play.
To search for a particular passage during playback (track scanning at high speed)
Press and hold the TUN.+/ or TUN.-/ button to scan the current playing track at high
speed until desired point passage, and then release the button. Playback will start again from
this point.
PROGRAM TRACKS
Programming tracks of disc are possible when playback is stopped. Up to CD 20 tracks can be
stored in the memory in any order.
1. In stop mode, press the PROG./M./P-MODE button, the P01 will be on and “PROG” will flash
on the display.
2. Press the TUN.+/ or TUN.-/ button to select the first desired track to be programmed.
Press the PROG./M./P-MODE button to enter. The display changes to show P02.
3. Repeat steps 1 & 2 to store other desired tracks until all tracks are programmed.
4. Press the button to start playback from the first programmed track.
5. Press the STOP button to stop program playback. To clear the program, you may press the
STOP button when the disc stopped and open the CD compartment lid, program will be
erased.
To Next Page
Loading...