EasyManuals Logo

Rega AETHOS User Manual

Rega AETHOS
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
Thermal cut-out and DC protection
If the amplier reaches a temperature liable to cause internal
electronic damage, a thermal protection sensor will shut the unit
off. If this occurs, there will be no sound emitted from the speakers.
The unit should be turned off for at least 10 minutes to allow for
cooling. After this period, the amplier should automatically reset and
continue to work normally. If it does not, turn the unit off for a longer
period, allowing complete cooling of the amplier before retrying.
The thermal cutout should only occur with continuous high level
driving of a difcult load. If it occurs under normal conditions, there
could be a problem with insufcient airow around the heat sinks or a
fault with the loudspeakers. In this case it is advisable to contact your
Rega dealer.
One of the design requirements of the AETHOS was to keep the
capacitors in the signal path to a minimum to prevent unnecessary
sound degradation. In order to achieve this requirement, the outputs
of both the pre-amplier and power amplier (speaker) are DC
coupled. A servo control is applied to the pre-amplier. In the unlikely
event of a circuit failure causing any one of the above outputs to
produce an excessive DC voltage, the DC protection will activate
within milliseconds, protecting any connected device.
Operating temperature and short circuit protection
The recommended ambient operating temperature is 5 °C to 35 °C.
Allow adequate air circulation around the heat sinks on the left and
right hand sides, as these are the heat sinks for the power amplier
and will run hot with high listening levels. This unit is intended for use
in moderate climates.
If in the event that the speaker leads are shorted, the fold back
short circuit protection will protect the output stage from excessive
currents. This protection circuit is not placed in the audio signal path
and therefore does not affect sound quality.
Warning: To reduce the risk of re, electric shock or product damage,
do not expose the unit to rain, moisture, dripping or splashing and
ensure that no objects lled with liquids, such as vases, shall be
placed upon it. Do not remove the case covers. There are no user
serviceable parts inside.
No naked ame sources, such as lighted candles, should be placed on
the apparatus.
Remote control
The Solaris system remote (supplied) is a system remote handset. It
allows you to operate all the various remote controllable functions
of this and many other Rega products (batteries included - 2 x AAA
Alkaline).
AETHOS
4
World class hi- made in England. | www.rega.co.uk
World class hi-made in England. | www.rega.co.uk

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rega AETHOS and is the answer not in the manual?

Rega AETHOS Specifications

General IconGeneral
TypeIntegrated Amplifier
Weight17.5 kg
Power Output125 W per channel into 8 Ω
Outputs1 x Record Out (RCA), 1 x Preamp Out (RCA)
Dimensions432 mm (W) x 360 mm (D) x 120 mm (H)
Input Impedance47 kΩ
Signal to Noise Ratio> 105 dB
Inputs5 x Line Level Inputs (RCA)
THD+N< 0.007%

Related product manuals