Built-in phono stage
to amplify the signal from a moving magnet cartridge to a suitable level for
simple connection to a wide variety of products using either the standard
Note:
Output connections
Connect the output sockets of the built-in phono stage to a suitable ‘line
IMPORTANT:
‘Disk’ input.
Output connections Power connection
Note:
If this option is available, we recommend that the connection used for
the turntable is set to the lowest gain setting to avoid any unnecessary
background noise.
Note:
the speakers. This is the phono stage powering up momentarily after the
turntable. This is perfectly normal.
Positioning
level surface. Never place the turntable on the same surface as desktop
or bookshelf loudspeakers as the energy created by the loudspeakers
can distort the music and affect performance. To optimise performance,
wallbracket.
Power connection
now complete. Simply switch on, sit back and enjoy!
Service
user serviceable parts inside. If the unit performs erratically or emits smoke
technician.
Warranty
invalidate the warranty. If returning goods for inspection to your retailer, the
original packaging must be used to preserve the warranty. Damage caused
during transport due to incorrect packaging may invalidate your warranty.
Replacement packaging is available from any Rega retailer. Your statutory
rights are not affected.
Warning
Only use the supplied mains adaptors with this product.
PS1 (UK)
PS1 (EU - Euro 2 pin)
PS1 (Australian)
PS1 (UL - American)