Regal-Beloit GE ECM X13 - Page 64

© 2006 GE ECM by Regal-Beloit - 62 - Indoor Blower Motors v0.2
Premium Motor Control Disassembly Review
Step 1
– Unplug the 16-pin connector
and the 5-pin connector from the motor
control.
Step 2
– Remove the blower assembly
from the HVAC system.
Step 4
- Unplug the 3-pin connector from
inside the control by squeezing the latch
and gently pulling on the connector.
Step 3
– Remove the two (2) hex-head
screws from the back of the control.