9
Genteq does not condone the repair of any individual
components in the motor control or motor of their
ECM products. This practice is unsafe and may cause
personal injury, death, or property damage.
WARNING
Working on the motor with power connected may result
in electrical shock or other conditions that may cause
personal injury, death or property damage.
WARNING
On models 2.0 / 2.3 / 2.5 / Eon
®
/ 3.0 / Endura
®
Pro always
disconnect the power from the HVAC system and wait at
least 5 minutes before opening the motor, i.e. removing
the two bolts from the motor control (end bell) and
disconnecting the 3-pin plug to the motor. This is to
allow the capacitors to dissipate for safety.
WARNING
Always disconnect the power from the HVAC system before
removing or replacing connectors, servicing the motor,
removing the high voltage plug, and before reconnecting.
WARNING
Disconnect AC power from the system and make sure
the blower wheel or fan blade has come to a complete
stop before servicing the motor.
WARNING
Do not operate motor without blower wheel or fan blade
attached. Such operation will cause the motor speed to
oscillate up and down.
WARNING
You must have the correct replacement module and/
or motor from the HVAC unit manufacturer that is a
direct replacement for the failed module and/or motor.
USING THE WRONG MODULE AND/OR MOTOR VOIDS
ALL PRODUCT WARRANTIES AND MAY PRODUCE
UNEXPECTED RESULTS.
WARNING
9
To Next Page